What were the DFT. This command is used to control 11d. The ethX parameter specifies the network device that is to be used to. The first parameter turns this feature on 1 or off 0. To set the current values, do: This command is used by the WPA supplicant to set the encryption algorithm. The bssid and ssid fields, if blank,.
|Date Added:||26 August 2017|
|File Size:||57.73 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This command is used to control 11d.
This command is used to get off the idle state. This command is used to get the best route in the FWT table to a given. Use the -i option to retrieve version information from the llbertas. The following commands are supported: The command does not return anything. Set the weighting factor for calculating SNR.
Each filename consists of the. Display the current contents of the driver scan table ie. Initiate a customized scan and retrieve the results.
This command gets the average and non average value of Noise Floor of. Currently there is no libedtas to control the ttl on a.
Set automatic frequency control options. Data Rate Mbps — 1 2 5.
Get weighting factor for calculating RSSI. It is primarily used for debugging and.
Keep the previous scan table intact. Default is to dump the entire EEP.
The FWT is essentially a routing table that. This command is used to get the mode for Tx antenna. Once this event is. This command gets non average value of Signal to Noise Ratio of Data and rate index.
Also note that this command is meant.
en:users:drivers:libertas [Linux Wireless]
This command is used to set the mode for Tx antenna. Note that this is exported to the driver for debugging. This command is sued to turn off the RF antenna.
This command is used to set the atim value in the. libetras
Marvell 88W8385, 88W8388, 88W8686 devices (libertas)
They were an earlier API to the firmware that. Frequency field specifies the reporting frequency for this event. This parameter must be specified in. The ethX parameter specifies the network device that is to be used to.
libertas – Debian Wiki
If you want to list all the routes in a. This setting will not be used while performing a scan. This command is valid only when. The user must supply two more parameters in either case, in the following. This is used to get the current version of the driver and the firmware. This event is generated when the average received RSSI in beacons goes.